Clarke Machinery Group

Overhead sheet spreading has developed; gone are the clouds of slurry behond a tanker that is black with splashes.
Today, sheet spreading is close to the ground and the amount caught by the wind is greatly reduced
thanks to accurate distributors which drive the slurry towards the ground and above all thanks to the multi-nozzlebooms.
They divide the sheet into multiple "umbrellas" and provides distinctly more consistent transverse distribution.
The 3 kind of dribble bar are the Multitwist, Twinjet and Penditwist

Multitwist Boom

The JOSKIN Multitwist multi-buzzards spreading boom is an equipment that allows to spread the slurry on a larger width(12m to 15m according to model) by spreading it close to the ground in "umbrella" jets. The system is composed of two principal buzzards supported by triangular frames. On the 12m model the principal buzzards each carry 4 exit tubes on which are anchored the projection mechanism. A 1.5m extension can be easily mounted on each side of the boom to increase the width from 12m to 15m.

Click here to contact us regarding the Multitwist Boom

Multitwist Boom Features

- 8/10 umbrella jets for 12 or 15m spreading with low wind intake and good repartition
- Direct feeding
- Integrated anti-drip raising TWIST SYSTEM
- Anti-crash safety device 5cm (refolding)
- Hydraulic Folding
- Galvanised connection spacers with height adjustement
- Boom bracket support
- Distribution box with flanged couplings

Twinjet Boom

The double buzzard TWINJET spreading boom is an equipment allowing to spread slurry in a traditional way but over a larger width. The slurry transfer system is based on the compression of the tank. At the end of the tank, the slurry flow is divided by means of a distribution box with 2 exits; then it is ejected through two tubes to the two scatterers who will spread it over adjustable widths.

Click here to contact us regarding the Twinjet Boom

Twinjet Boom Features

- Boom with 2 swinging motion spreading
- Direct feeding through 125mm buzzards
- Hydraulic folding
- Distribution box with small stonetrap
- Galvanised connection spacers with height adjustment
- Boom bracket support

Penditwist Boom

The Penditwist allows you to lay slurry at the foot of the vegetation without slowing down the growth of this vegetation and without lifting the foraging.
The working principle of the Penditwist is the following: the slurry coming from the tank goes through macerator
before going through the delivering pipes of the booms which lay the slurry in a delicate way down at ground level.

Click here to contact us regarding the Penditwist Boom

Penditwist Boom Features

- Hydraulic folding DA with hydraulic safety
- 1 or 2 SCALPER choppers with manual discharge adjusting value and counterblade
- Intehrated anti-drop raising Twist System
- Anti-crash safety device 60cm
- Unbroken delivery pipes from the chopper to the ground
- Connection and height adjusting spacers and parking stands
- Transport bracket with vertical and lateral stop devices
- Boom fully galvanised dribble bar

Clarke Machinery Group - New Inn, Ballyjamesduff, Co. Cavan, Ireland

Tel: +353 49 854 4353